[제품스펙]
•믹스 채널 : 모노 × 32 스테레오 × 8
•버스 : 16 Mix 8 Matrix (Input to Matrix에 대응)
•페이더 구성 : 16 + 2 (마스터)
•로컬 I / O : 16 IN, 8 OUT
•옵션 RK1으로 랙 장착 가능 (13U 공간이 필요 / 케이블 접속 부분 미포함)
일반 사양
| 샘플링 주파수 속도 |
내부 |
44.1kHz / 48kHz |
| 외부 |
44.1kHz: +4.1667%, +0.1%, -0.1%, -4.0% (±200ppm), 48kHz: +4.1667%, +0.1%, -0.1%, -4.0% (±200ppm) |
| 신호 지연 |
Less than 2.5ms, INPUT to OMNI OUT, Fs= 48kHz |
General specifications
| Fader |
100mm motorized, Resolution=1024steps, +10dB to –138dB, –∞dB all faders |
일반 사양
| 총 고조파 왜곡 |
Less than 0.05% 20Hz-20kHz@+4dBu into 600Ω, INPUT to OMNI OUT, Input Gain= Min. |
| 주파수 응답 |
+0.5, -1.5dB 20Hz-20kHz, refer to +4dBu output @1kHz, INPUT to OMNI OUT |
| 동적 범위 |
112dB typ.: DA Converter / 108dB typ.: INPUT to OMNI OUT, Input Gain = Min. |
| 전기 및 유도 잡음 수준 |
상응하는 입력 잡음 |
-128dBu typ., Equivalent Input Noise, Input Gain=Max |
| 잉여 입력 잡음 |
-88dBu, Residual output noise, ST master off |
| 크로스 토크 |
-100dB*1, adjacent INPUT/OMNI OUT channels, Input Gain = Min. |
| 전원 요구 사항 |
100-240V 50/60Hz |
| 전력 소비 |
135W |
| 크기 |
W |
468mm(18.4in ) |
| H |
272mm(10.7in) |
| D |
562mm(22.1in) |
| 순 무게 |
14.7kg(32.4lb) |
| 부속품 |
Owner’s Manual, power cord, DVS license sheet |
General specifications
| Options |
Rackmount kit RK1, Mini-YGDAI cards *2 , Gooseneck Lamp LA1L, Nuendo Live |
| Others |
Operating temperature range: 0 - 40℃, Storage temperature range: -20 - 60℃ |
Crosstalk@1kHz : A 22kHz, 30dB/Oct filter is used to measure crosstalk.
Total Harmonic Distortion : An 80kHz, 18dB/Oct filter is used to measure total harmonic distortion.
Hum & Noise : An A-Weight filter is used to measure hum &noise.
Analog input characteristics
| Input Connectors |
GAIN |
Input
Impedance |
Source
Impedance |
Input level |
Connector |
| Sensitivity*¹ |
Nominal |
Max. before clip |
INPUT
1-32 *6 |
+66dB |
7.5 kΩ |
50-600 Ω
Mics &
600 ΩLines |
–82dBu
(61.6μV)
|
–62dBu
(0.616mV)
|
–42dBu
(6.16mV)
|
XLR-3-31
type
(Balanced) *2 |
| –6dB |
–10dBu
(245mV) |
+10dBu
(2.45V) |
+30dBu
(24.5V)
|
*1. The sensitivity is the input level required for output at +4dBu (1.23V) or at the defined level when all the faders and level
controllers are set to the maximum value.
*2. XLR-3-31 connectors are balanced jacks (1=GND, 2=HOT, 3=COLD).
*3. 0dBu=0.775 Vms for all specifications.
*4. All the AD converters use 24-bit linear/128-times oversampling.
*5. The INPUT connectors have +48V DC (phantom power) jacks, each of which can be turned on/off individually from the console software.
*6. QL1: INPUT1-16
Analog output characteristics
Output
Connectors |
Output
Impedance |
Load
Impedance |
Maximum
Output
Level *5 |
Output Level |
Connector |
| Defined Level |
Maximum
Non-Clip Level |
OMNI
OUT 1-16 *7 |
75 Ω |
600 Ω
Lines |
+24dB
(default) |
+4dBu
(1.23V) |
vt+24dBu
(12.3V) |
XLR-3-32 type
(Balanced) *1 |
| +18dB |
–2dBu
(616mV) |
+18dBu
(6.16V) |
| PHONES |
15 Ω |
8 Ω
Phones |
- |
75mW *6 |
150mW |
Stereo Phone
Jack(TRS)
(Unbalanced) *2 |
40 Ω
Phones |
- |
65mW *6 |
150mW |
*1. XLR-3-32 connectors are balanced jacks (1=GND, 2=HOT, 3=COLD).
*2. The PHONES connectors for stereo headphones are balanced jacks (Tip=LEFT, Ring=RIGHT, Sleeve= GND).
*3. 0 dBu=0.775 Vms for all specifications.
*4. All the DA converters use 24-bit linear/128-times oversampling.
*5. The console has an internal switch for toggling the maximum output level.
*6. This is a value measured with the PHONES LEVEL knob set to 10 dB below the maximum position.
*7. QL1: OMNI OUT 1-8
Digital input/output specifications
| Connectors |
Format |
Data length |
Level |
Audio |
Connector |
| Primary/Secondary |
Dante |
24bit or 32bit |
1000Base-T |
64ch Input/64ch
Output@48kHz *1
|
EtherCON Cat5e
|
*1. QL1: 32ch Input/32ch Output@48kHz
Digital output specifications
| Connectors |
Format |
Data length |
Level |
Connector |
| DIGITAL OUT |
AES/EBU |
AES/EBU Professional Use |
24bit |
RS422 |
XLR-3-32 type (Balanced) *1
|
*1. XLR-3-32 connectors are balanced jacks (1=GND, 2=HOT, 3=COLD).
I/O SLOT (1-2) specifications
Each I/O Slot accepts a Mini-YGDAI card.
Only Slot 1 has a serial interfac
Control I/O characteristics
| Connectors |
Format |
Level |
Connector |
| MIDI |
IN |
MIDI |
- |
DIN Connector 5P |
| OUT |
MIDI |
- |
DIN Connector 5P |
| WORDCLOCK |
IN |
- |
TTL/75 Ω terminated |
BNC Connector |
| OUT |
- |
TTL/75 Ω |
BNC Connector |
| GPI (5IN/5OUT) |
- |
- |
D Sub Connector 15P(Female) *1 |
| NETWORK |
IEEE802.3 |
10BASE-T/100Base-TX |
RJ-45 |
| LAMP (QL5: x 2, QL1: x 1) |
- |
0V-12V |
XLR-4-31 type *2 |
| USB HOST |
USB 2.0 |
- |
USB A Connector (Female) |
*1. Input pin: TTL level, w/ internal pull-up (47kΩ) Output pin: Open drain output (Vmax=12V, maximum sink current/pin=-75mA) Power supply pin: Output voltage Vp=5V, Max. output current=300mA
*2. 4 pin=+12V, 3 pin=GND, Lamp nominal power: 5W, Brightness (voltage) can be adjusted from the software. | |
|
현재위치 : 
