높은 인풋 용량과 많은 페이더의 수는 대용량 어플리케이션에 적합한 강력한 콘솔을 만들어줍니다.
- 33페이더(32채널+1마스터)
- 48믹싱채널(40모노+2스테레오+2리턴)
- 20AUX(8모노+6스테레오)+STEREO+SUB버스
- 8DCA그룹(DCA Roll-out기능탑재)
- 32아날로그 XLR/TRS콤보 입력 단자(마이크/라인)+2아날로그 RCA핀 스테레오 입력단자(라인)
- 16아날로그 XLR출력단자
- 34트랙 녹음/재생(USB2.0)+2트랙 녹음/재생(USB저장장치)
- NY64-D용 확장 슬롯
사양
Outline
| Fader Configuration |
32 + 1 (Master) |
| Mixing Capacity |
Input Channels |
48 (40 mono + 2 stereo + 2 return) |
| Aux Buses |
20 (8 mono + 6 stereo) |
| Stereo Buses |
1 |
| Sub Buses |
1 |
개요
Outline
| I/O |
Inputs |
32 mic/line (XLR/TRS combo) + 2 stereo line (RCA pin) |
| Outputs |
16 (XLR) |
개요
Outline
| On-board processors |
DSP |
8 Effects + 10 GEQ |
| USB |
34x34 USB Audio Interface, 2-track recording via USB Storage Device |
일반 사양
| 샘플링 주파수 속도 |
내부 |
48 kHz |
| 신호 지연 |
Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz |
General specifications
| Fader |
100 mm motorized, Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders |
일반 사양
| 총 고조파 왜곡 |
Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz) |
| 주파수 응답 |
+0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT |
| 동적 범위 |
110 dB typ., DA Converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min. |
| 전기 및 유도 잡음 수준 |
상응하는 입력 잡음 |
–128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter) |
| 잉여 입력 잡음 |
–85 dBu, ST master off (Measured with an A-Weight filter) |
| 크로스 토크 |
–100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min. |
| 전원 요구 사항 |
100–240 V 50/60 Hz |
| 전력 소비 |
120 W |
| 크기 |
W |
866 mm (34.1in) |
| H |
225 mm (8.9in) |
| D |
599 mm (23.6in) |
| 순 무게 |
20.0 kg (44.1lb) |
| 부속품 |
Quick Guide, Power Cord, CUBASE AI download information |
General specifications
| Options |
Expansion Card, Foot Switch (FC5) |
| Others |
Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C |
Analog input characteristics
| Input Terminals |
GAIN |
Load
Impedance |
For Use With
Nominal |
Input Level |
Connector |
balanced /
Unbalanced |
| Sensitivity*1 |
Nominal |
Max. before clip
|
| INPUT1-32 |
+66dB |
7.5KΩ
|
50-600Ω Mics
or 600 Ω Lines
|
-82dBu (61.6 V) |
-62dBu (0.616mV) |
-42dBu (6.16mV) |
Combo Jack (XLR-3-31 type *2
or TRS phone *3) |
Balanced |
| -6dB |
-10dBu (245mV) |
+10dBu (2.45V) |
+30dBu (24.5V) |
| ST IN 1,2 |
— |
10kΩ |
600 Ω Lines |
-30dBV (31.6 V) |
-10dBV (316mV) |
+10dBV (3.16V) |
RCA Pin Jack |
Unbalanced |
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
| Output Terminals |
Source
Impedance |
For Use With
Nominal |
GAIN SW |
Output Level |
Connector |
balanced /
Unbalanced |
| Nominal |
Max. before clip |
| OMNI OUT 1-16 |
75 Ω |
600Ω Lines
|
“+24dBu” position (default)
|
+4dBu (1.23 V) |
+24dBu (12.3 V) |
XLR-3-32 type *1 |
Balanced |
| PHONES *3 |
100 Ω |
40Ω Phones |
— |
3mW |
75mW |
Stereo Phone Jack (TRS) *2 |
Unbalanced |
*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.
Digital input/output specifications
| Terminals |
Format |
Data length |
Audio |
Connector |
| USB (TO HOST) |
USB |
24bit |
34ch input / 34ch output, PCM |
USB (B type) |
| iPad |
USB |
— |
Playback: MP3 or WAV file data / Record: WAV file data
|
USB (A type)
|
Control I/O specifications
| Terminals |
Format |
Level |
Connector |
| NETWORK |
IEEE802.3 |
10BASE-T/100Base-TX |
RJ-45 |
| FOOT SW |
— |
— |
TS Phone
| | |
|
현재위치 : 
